User guide

Single-End Line Testing (SELT) Port Management (non-iMAP Devices)
5-223
AlliedView NMS Administration Guide (Controlling and Provisioning Network Devices)
FIGURE 5-205 Running the SELT Test
Select OK, and the test will begin. As it goes through testing, the state will change, until the test is complete and with a status
of Success. Refer to the following figure.
FIGURE 5-206 SELT Test Complete
Once the test is complete, the user can view the results on a browser or save the test results for later analysis. The interface to
review test results is similar to those used for DELT and is described in 5.7.3.