User guide

Port Management (iMAP Devices) ATM Bonding
AlliedView NMS Administration Guide (Controlling and Provisioning Network Devices)
5-204
5.6.31 ATM Bonding
For ATM Bonding, the following figures show which panels have changed.
5.6.31.1 Status
The status tab includes the status of the ATMBond as well as the associated ports. Refer to the following figure.
FIGURE 5-187 Status Tab for ATMbond
5.6.31.2 ADSL Configuration - ATMBOND
The General subtab for ATM Bonded ports gives information on both the ATM Bond and the ADSL members.
For the ATMBOND tab, there is the button “Add Bonded Port..” to allow adding another port to the group. This button is dis-
abled when the group is full. Currently only two pairs can be bonded, (although a group can be created with only one pair).
The “Remove Port…” button is used to remove the displayed port from the Bond Group and “Add Port” to add a new one.
The ATMBOND interface will include the “Interface Profile Name” to support the External Profile feature, also added in 11.0
Enable Enabled if the port is in an Administrative State of DOWN, enables the port and so brings
the Administrative State to UP. If possible (for example, the ADSL card must be enabled),
the Operational State will change to UP.
Disable Enabled if the port is in an Administrative State of UP, disables the port and so brings the
Administrative State to DOWN. The Operational State will also change to DOWN.
Alarms Invokes the Alarm table of the Fault Management Object.
TABLE 5-55 ADSL Configuration Form, Video Tab (Continued)
Field/Button Description