User guide

Port Management (iMAP Devices) NTE8 Port Management Form
AlliedView NMS Administration Guide (Controlling and Provisioning Network Devices)
5-182
5.6.21.1 DS1/E1 Port Tab
FIGURE 5-170 NTE DS1 Port Management Form - DS1/E1 Tab
TABLE 5-48 NTE DS1 Port Management - DS1 Port Tab
Field/Button Description
Device: / Port: Non-editable, this is the port (or ports) that are being displayed.
Admin. State/Status: Administrative State of the port. This depends on the state of the associated card.
Oper. State/Link Status Operational State of the port. This depends on the Administrative state of the port.
Status The same attributes as for other cards
Type: NTE-DS1 or NTE-E1
Framing Always ESF
Timing Reference Where the port receives its clocking source from (SELF or CARD).
Profile: The port profile being used. This is the first editable field.
Note: A profile must have been previously created.
Description Where the user can add an appropriate description for what the port provides
Line Encoding Either B8ZS (DS1) or HDB3 (E1). This should not be changed, unless the card is being
re configured.
Line Build Out: The line build out, either in db (long-haul) or feet (short-haul)
Loop Back Status
The DS1/E1 port is considered operationally DOWN when a loopback is con-
figured, because no “thru service” can be provided. Therefore, when a loopback
is configured on the interface, an administratively UP interface would be “UP-
DOWN-Loopback”", while an administratively DOWN interface would be
“DOWN-DOWN-Loopback”