User guide

Port Management (iMAP Devices) Voice Port Management (Tabbed Form)
AlliedView NMS Administration Guide (Controlling and Provisioning Network Devices)
5-168
Status: The status of the port that follows form the Administrative State and Operational State.
For meanings, refer to the iMAP User Guide, Section 4.
- ONLINE
- IN TEST
- FAILED
- OFFLINE
- DEPENDENCY
- DEGRADED
- NOT INSTALLED
- INITIALIZATION REQUIRED
- TERMINATING
POTS Protocol Whether the card is using MGCP or SIP protocol
Profile: Profile used that pre-populates many of the port attributes.
Description (Customer ID): Customer ID for the port. Refer to 7.2.7.
Capability Specifies the Codec capabilities advertised to the Call Agent:
- PCMU: G.711 mu law (specified in CCITT/ITU-T recommendation G.711)
- G726-32: CCITT/ITU-T recommendation G.726
- All: all of the above
Min. Packetization: The minimum number of milliseconds of voice data that can be encoded in a data
packet. This value is advertised to the Call Agent. The default is 20 msec.
Note: To support Call Waiting with Caller ID, this attribute should be
set to 10 milliseconds.
Max. Packetization The maximum number of milliseconds of voice data that can be encoded in a data
packet. This value is advertised to the Call Agent. The default is 20 msec.
Note: To support Call Waiting with Caller ID, this attribute should be
set to 10 milliseconds
Jitter Buffer Delay: Used with jitter buffering, this is the amount of time that the first packet is delayed.
This delay is then used to smooth out jitter on subsequent arrivals.
The default is 30 msec
Jitter Buffer Mode: The jitter buffer mode. A jitter buffer is used to compensate for the jitter in packet
arrival and out-of-order packets. A large jitter buffer causes increase in the delay and
decreases the packet loss. A small jitter buffer decreases the delay but increases the
packet loss.
DYNAMIC - This mode minimizes delays and is the default.
Voice Activity Detection: Specifies whether to advertise Voice Activity Detection (VAD) capability to the Call
Agent. VAD is used for silence suppression, and will reduce the transmission rate dur-
ing inactive speech periods while maintaining an acceptable level of output quality.
ON: VAD is supported. This is the default
Echo Cancellation: Echo Cancellation in ms for period capability is advertised to the Call Agent.
Modem Jitter Buffer Delay Used with jitter buffering, this is the amount of time that the first packet is delayed.
Note: The default in release 8.0 was changed from 30ms to 10ms
TABLE 5-42 POTS24 Voice Configuration Tab - POTS
Field/Button Description