User guide

Port Management (iMAP Devices) ADSL Configuration Tab
AlliedView NMS Administration Guide (Controlling and Provisioning Network Devices)
5-148
The values on this form can be modified as follows:
Note: This requires that the port be disabled, which will interrupt service on the port.
1. Click Disable to disable the port. A dialog box will appear warning you that service on the port will be interrupted. If you
wish to proceed, click Yes .
2. Modify the information as needed.
3. Click Modify to save the changes.
4. Click Enable to re-enable the port.
For an ADSL Bonded port, the General Tab of the Port Details window contains information about the ATMBond. Each ADSL
port that belong to the bond group has its own tab. There is the button on the panel “Add Bonded Port.”, to allow adding
another port to the group. This button is disabled when the group is full. Refer to the following figures.
Note: Currently only two pairs can be bonded, but a group can be created with only one pair.
Power Mgmt Trim The maximum aggregate transmit power reduction (trimming) that can be performed with
each power trim operation in the Low Power state.
Power Mgmt Trim Delay The amount of time that must elapse before an additional reduction (trimming) of power
occurs in the Low Power state.
Low Power Min Rate The minimum net data rate for the bearer channel while operating in the Low Power state.
The value for LOWPOWERRATE must be between MAXDOWNSTREAMRATE and
MINDOWNSTREAMRATE
Max. Upstream Nominal
PSD
VDSL/ADSL power spectrum density limits are defined by the band plan and determine
this value.
Max. Downstream Nominal
PSD
VDSL/ADSL power spectrum density limits are defined by the band plan and determine
this value.
Modify Enabled when a value in New Value field has been entered, modifies the attributes accord-
ing to the updated values.There is an error message if a value is invalid.
Clear Entry Fields Clear any fields that have been datafilled but not yet Modified
Enable Enabled if the port is in an Administrative State of DOWN, enables the port and so brings
the Administrative State to UP. If possible (for example, the ADSL card must be enabled),
the Operational State will change to UP.
Disable Enabled if the port is in an Administrative State of UP, disables the port and so brings the
Administrative State to DOWN. The Operational State will also change to DOWN.
Alarms Invokes the Alarm table of the Fault Management Object.
TABLE 5-36 ADSL Configuration Form, General Tab (Continued)
Field/Button Description