User guide

Card Management POTS24 Card
AlliedView NMS Administration Guide (Controlling and Provisioning Network Devices)
5-102
TABLE 5-22 POTS24 SIP Attributes - (Defaults are in Bold)
POTS24 Card Attribute Description
Profile
The Profile that has been applied to the card
Transport The Transport type of the outgoing messages.
When set to UDP Accept TCP, the IP Phone will accept incoming TCP messages.
(TCP)
TCP Port The TCP port on which the Stack listens. (5060)
UDP Port The UDP port on which the Stack listens (5060)
Registrar (Host port) The Registrar IP address or domain name. If this parameter is not set, Registra-
tion messages will not be sent. NULL
(The number of the Port on which the Registrar listens)
Outbound Proxy (Host
Port)
The IP address of the outbound Proxy. If this parameter is set, all outgoing mes-
sages (including Registration messages) will be sent to this Proxy.
The outboundProxyHostName can be used for setting the IP address or the DNS
name that the call application can parse NULL
(The number of the Port on which the outbound Proxy listens)
User Domain This domain name will be sent in the From header of outgoing Invite messages
Registration Time-out The time-out (in seconds) for sending Proxy Re-registration requests 3600
Unregistration Time-out This parameter is relevant for unregistration requests that are sent as part of the IP
Phone Toolkit shutdown process. The time-out (in seconds) indicates the time
interval to wait for a reply after sending an unregister request before completing
the shutdown process. If the time-out expires before a reply has been received,
the shutdown process will be completed. If a reply is received before the time-out
expires, the IP Phone Toolkit will respond accordingly and then complete the
shutdown process. 20
Refer Time-out The time-out (in milliseconds) for waiting for Notify after sending Refer, before
disconnecting the call-leg 2000
Dialtone Duration Duration of Dial Tone signal (in milliseconds) when going off-hook. When the
subscriber goes off-hook and time-out expires, Dial Tone will be stopped and the
connection will disconnect. 0 indicates an infinite Dial Tone. 3000
Call Waiting Reply When the incoming call is a Call Waiting call, this parameter indicates which SIP
message will be sent as a reply to the Invite.
DSCP Settings (0..63) The DSCP (Differentiated Services Code Point, RFC 2474) value for SIP packets transmit-
ted from the POTS24 card. 34
VLAN P bits (0..7) The 802.1p priority bit setting for SIP packets transmitted from the POTS24 card. 5
Call Forwarding Uncon-
ditional Sub-tab
ON-Prefix
ON-Suffix
OFF-Prefix
After CFW Unconditional has been activated, incoming calls are forwarded inde-
pendently of the status of the endpoint.