User guide

Overview Card Management
5-83
AlliedView NMS Administration Guide (Controlling and Provisioning Network Devices)
Note: To see the status of a port, place the cursor over a port in the graphic and a tooltip appears, which shows
the permitted states for that port. Allowed states are Plain, Tagged, Untagged, Linked-Tagged, Unlink-
Tagged, Linked, and Translated. (The actual states available depend on the configuration.) If a port is
Plain, the user can then click on the port and cycle the status from U (untagged) to T (tagged) to X
(translated). Clicking on the port again will return the port to blank. When a port is marked as untagged
for a VLAN other than the default VLAN, that port can only be marked as tagged for the other VLANs. In
this case the port alternates only between tagged and blank.
Note: For the EPON2 card, the user can click on the ONUs button and a pop-up will show the VLAN status of
the ONU ports. To close the pop-up, click on the square labeled Port <no.> ONUs, as highlighted in
Figure 5-91.
Note: To change the status for a set of ports, select and hold the SHIFT key and then click and drag the left
mouse button over multiple ports.
Caution: The FE/FX10 cards have certain restrictions on VLAN translations, and the user must be aware
of these so as not to compromise service. Refer to 6.9.3.2.
FIGURE 5-92 Entering a translated VLAN (State will go from U to X)
5.5 Card Management
5.5.1 Overview
This application for the iMAP 9000 and SBx3112 devices allows the user to view, in a table format, the configuration of the
device and then provision/configure its cards. Moreover, this table is updated real time as changes occur to the cards.
View Last
Action
This will open up the Recent Commands... window and show what command and response were
involved in the last action on the form.
Close Closes the form.
Note: If this VLAN Configuration form is invoked from the Chassis View, the
Close button is replaced with the Chassis View button, to return to the first
view of the device.
TABLE 5-12 VLAN Configuration Options
Screen Item Description