User guide

Software Configuration (Custom Loads) Provisioning a Device
5-51
AlliedView NMS Administration Guide (Controlling and Provisioning Network Devices)
FIGURE 5-53 Custom Device Loads Form - Custom Load
To add a new type, begin by choosing the type from the combo box in Type Details, as shown in Figure 5-54. The file keys
for the type are predefined and will appear in the File Keys column. The File Names will normally be blank, but in some
cases where a file name was listed for the same key from the previous type, if any, the name will default to the previous
name. (In some cases the same file names are usable for the same keys in different types, but in general, different device
types have different keys)
If the type selected from the combo box already exists in the load, its row in the table above will be highlighted and its
details will be defaulted to their existing values.
Push the Add button after entering all the details and verify the new type is added to the table. If you do anything else instead
of pushing the Add button, a popup dialog will ask whether or not to finish the addition for the device.