User guide

Provisioning a Device Software Configuration (Standard Loads)
AlliedView NMS Administration Guide (Controlling and Provisioning Network Devices)
5-40
The Clear All button, un-selects (unchecks) all rows.
The Delete Files button deletes all files from all selected (checked) bundles. If any errors occur during the deletion, an error
dialog will pop up with an error message.
FIGURE 5-42 Purge Load Files
5.3.9.4 Using a MTAC Account and WebGen (Manual) to Enable Software Upgrades
To enable software upgrades for Rapier devices, a two-step process is used that involves tasks at an Allied Telesis website as
well as a AlliedView NMS feature:
1. The Multi-Time-Access-Code (MTAC) is a website where customers can register themselves and then set up for their
devices (based on the serial numbers) the OSs that will be loaded.
2. The WebGen Import Form tool (on the AlliedView NMS) is then brought up, and the results from the MTAC account are
copied either directly into the form or are copied into a file so that it can be copied into the form later.
To access your MTAC account, go to https://licence.alliedtelesis.co.nz/mtac/fusebox.cfm.
Note: Before accessing this site, you will need to obtain a valid user ID and password from your authorized Allied
Telesis representative or reseller.
Once you have accessed the site, you will go through a series of forms where you enter your id, password, give general cus-
tomer details, and correlate an OS with the serial numbers of your devices. You must also fill in details on the device for each
serial number. (Note that you do not have to enter information for all your devices and can revisit your account later.) After
clicking on Generate, a list of ENABLE commands is produced that selects the OS for the devices and include the passwords.
Note: The instructions above are at a general level because detailed instructions about using your MTAC to
generate licences are at www.alliedtelesis.co.nz/webgen/pdf/webgen-customer-guide.pdf.
Once you have this list of commands generated with the account, you can use the results in one of two ways: