Installation guide

Electrical Safety and Installation Requirements
16
RADIATED ENERGY
RFI Emission EN55022 Class B
WARNING
: This product requires shielded cables to comply with Class B emission limits. If
not used with shielded cables, this product may cause radio interference in which case the
user may be required to take adequate measures.
Immunity EN50082-1
Electrical Safety TUV-EN60950, UL1950, CSA 950
Laser EN60825
SAFETY
ELECTRICAL NOTICES
WARNING
: ELECTRIC SHOCK HAZARD
To prevent ELECTRIC shock, do not remove cover. No user-serviceable parts inside. This
unit contains HAZARDOUS VOLTAGES and should only be opened by a trained and qualified
technician. To avoid the possibility of ELECTRIC SHOCK disconnect electric power to the
product before connecting or disconnecting the LAN cables.
This is a “CLASS 1 LED PRODUCT”
LIGHTNING DANGER
DANGER
: DO NOT WORK on equipment or CABLES during periods of LIGHTNING
ACTIVITY.
CAUTION
: POWER CORD IS USED AS A DISCONNECTION DEVICE. TO DE-ENERGISE
EQUIPMENT disconnect the power cord.
INSTALLATION
ELECTRICAL - AUTO VOLTAGE ADJUSTMENT
This product will automatically adjust to any voltage between the ranges shown on the label.
ELECTRICAL - TYPE CLASS 1 EQUIPMENT
THIS EQUIPMENT MUST BE EARTHED. Power plug must be connected to a properly wired
earth ground socket outlet. An improperly wired socket outlet could place hazardous
voltages on accessible metal parts.
ELECTRICAL - CORD NOTICE
Use power cord, maximum 4.5 meters long, rated 5 amp minimum, 250V, made of <HAR>
cordage molded IEC 320 connector on one end and on the other end a plug approved by the
country of end use.
Canadian Department of Communications
This Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le
matériel brouilleur du Canada.