Installation guide

16
Note
For wall-mount installation, you must
supply the two screws and plastic
anchors or other material necessary to
physically mount the switch to the wall.
3. Install two plastic anchors and two pan-head
screws into the wall, separated by 5
centimeters (approximately 2 inches).
4. Position the device onto the wall screws.
5. Plug the power adapter into a power source
and plug the DC power cord into the DC
connector on the front panel of the switch.
Warning
The power cord is used as a
disconnection device. To de-energize
equipment, disconnect the power cord.
5
6. Make sure the Power LED on the front panel
lights green.