Installation guide

ManualsBrandsAllied Telesis ManualsComputer equipmentAT FS708LE AT-FS708LE AT-FS708LE

AT-FS708LE Installation Guide

15

5. Attach the data cables to the ports on the hub.

Do not use crossover cables to connect

workstations or servers to ports 1 through 8.

Do not use a crossover cable to connect a

switch, hub, or router to the Uplink port.

Note

You can use either port 8 or the Uplink

port on an AT-FS708LE device. You

cannot use both ports simultaneously.

6. Go to the procedure “Verifying and

Troubleshooting the Installation” on page 17.

Installing the Unit on a Wall

For wall-mount installation, you can position

the switch vertically or horizontally on the wall

using the keyhole cutouts in the bottom of the

switch chassis.

1. If previously attached, remove the rubber feet

and all cables and the DC power cord from the

switch.

2. Select a wall location for the switch.