Installation guide

14
Installing the Unit on a Desktop
To install the switch on the desktop, perform
the following procedure. To mount the unit on a
wall, perform the steps “Installing the Unit on a
Wall” on page 15.
1. Attach the four self-adhesive rubber feet to
the bottom of the device, positioning them in
the indentations.
2. Place the device on a flat, level surface.
3. Plug the power adapter into a power source
and then plug the DC power cord into the DC
connector on the front panel of the switch.
Warning
The power cord is used as a
disconnection device. To de-energize
equipment, disconnect the power cord.
5
4. Make sure the Power LED on the front panel
lights green.