Installation guide

SwitchBlade x8112 Chassis Switch Installation Guide
99
6. Insert the card into the slot until you feel it make contact with the
connector on the chassis backplane, as shown in Figure 58.
Figure 58. Inserting the AT-SBx81CFC400 Card in the Chassis Slot
Caution
Forcing the AT-SBx81CFC400 Card into its chassis slot when it is
not properly aligned with the card guides may damage the
backplane connector pins inside the chassis. If there is undue
resistance, remove the card. Check to be sure that it is properly
aligned with the card guides when sliding it into the chassis.
7. Secure the controller card to the chassis by closing the two locking
levers on the front panel of the card, as shown in Figure 59 on page
100.