Installation guide
Chapter 6: Installing the Transceivers and Cabling the Ports
122
Note
Do not remove the dust plug from the SFP+ slot if you are not
installing the transceiver at this time. The dust plug protects the line
card from dust contamination.
2. Orient the connector on the AT-SP10TW cable so that the release tab
is on top, as shown in Figure 78.
Figure 78. Release Tab on the AT-SBx81XS6 Line Card
3. Slide the connector into the slot until it clicks into place, as shown in
Figure 79.
Figure 79. Installing the AT-SP10TW Cable in the AT-SBx81XS6 Line
Card