Installation guide

AT-ANC10S/2 and AT-ANC10S/4 Adapters Installation and User’s Guide
73
IPv4 Large Send
Offload
Normally, the TCP segmentation is
done by the protocol stack. When
you enable the Large Send
Offload property, the TCP
segmentation can be done by the
network adapter. The default
setting for this property is Enabled.
This property is only available for
the ANC10S network adapters.
1. In Microsoft Windows, right-
click the Network Adapter in
Network Connections and then
click Properties.
2. Click the Configure button and
then the Advanced tab.
3. Set the desired IPv4 Large
Send Offload value.
IPv6 Checksum
Offload
Normally, the checksum function is
computed by the protocol stack.
When you select one of the
Checksum Offload property values
(other than None), the checksum
can be computed by the network
adapter.
Rx Enabled - Enables receive
TCP/IP/UDP checksum offload.
Tx Enabled - Enables transmit
TCP/IP/UDP checksum offload.
Tx/Rx Enabled - (default). Enables
transmit and receive TCP/IP/UDP
checksum offload.
None - Disables checksum
offload.
1. In Microsoft Windows, right-
click the Network Adapter in
Network Connections and then
click Properties.
2. Click the Configure button and
then the Advanced tab.
3. Set the desired IPv6
Checksum Offload value.
IPv6 Large Send
Offload
Normally, the TCP segmentation is
done by the protocol stack. When
you enable the Large Send
Offload property, the TCP
segmentation can be done by the
network adapter. The default
setting for this property is Enabled.
This property is only available for
the ANC10S network adapters.
1. In Microsoft Windows, right-
click the Network Adapter in
Network Connections and then
click Properties.
2. Click the Configure button and
then the Advanced tab.
3. Set the desired IPv6 Large
Send Offload value.
Table 8. Advanced Features in Microsoft Windows
Feature Description Configuration Steps