Installation guide

AT-ANC10S/2 and AT-ANC10S/4 Adapters Installation and User’s Guide

Removing the Device Drivers

This section discusses how to remove the device drivers.

Note

Windows Server 2008 and Windows Server 2008 R2 provide the

Device Driver Rollback feature that replaces a device driver with one

that was previously installed. However, the complex software

architecture of the ANC10S network adapters may present problems

if the rollback feature is used on one of the individual components.

Therefore, Allied Telesis recommends that changes to driver

versions be made only through the use of a driver installer.

To remove the device drivers, do the following:

1. In Control Panel, double-click Add or Remove Programs.

2. Click Broadcom NetXtreme II GigE Driver Installer, and then click

Remove. Follow the on screen prompts.

3. Click Yes to restart your system.

- or -

4. Click No to restart your system at a later time.

5. Click OK to acknowledge that the installation has been suspended.

The uninstallation of the driver is postponed until the next restart of

your system.