Installation guide

AT-ANC10S/2 and AT-ANC10S/4 Adapters Installation and User’s Guide
55
Installing the Windows Driver Software
This chapter describes how to install all of the following Windows
Operating Systems:
 Microsoft Windows Server 2008 (32-bit and 64-bit extended)
 Microsoft Windows Server 2008 R2
 Microsoft Windows Server 2012 and 2012 R2
The Windows driver software for all of the Windows Operating Systems is
available on the Allied Telesis website at www.alliedtelesis.com/
support/software. After you have accessed this website, enter the model
number in the Search by Product Name box and then click Find to
display the current list of software drivers.
There are two methods to install the software drivers on all of the Windows
Operating Systems: the Installer and Silent installation. The Installer uses
a graphical interactive mode. The Silent Installation is a command-line
interface for unattended installation. See the following sections:
 “Using the Installer” on page 56
 “Using Silent Installation” on page 60
Note
These instructions are based on the assumption that your adapter
was not factory installed. If your controller was installed at the
factory, the driver software has been installed for you.
Note
Before installing the driver software, verify that the Windows
operating system has been upgraded to the latest version with the
latest service pack applied.
Note
You must physically install a network device driver before the
ANC10S network adapter can be used with your Windows Operating
System. There is no installation CD. You must download the drivers
from the Allied Telesis website at www.alliedtelesis.com/support/
software. After you have accessed this website, enter the model
number in the Search by Product Name box and then click Find to
view the current list of documents and drivers.