Installation guide

AT-ANC10S/2 and AT-ANC10S/4 Adapters Installation and User’s Guide
39
Installing SFP+ Transceivers in the AT-ANC10S Adapters
Here are the guidelines to installing and cabling SFP+ transceivers in the
AT-ANC10S adapters:
 SFP+ transceivers can be hot-swapped while the adapter is
powered on. However, you should always disconnect the fiber
optic cables first before removing a transceiver.
 You should install a transceiver in the adapter before connecting
the fiber optic cable.
 Fiber optic transceivers are dust sensitive. Always keep the plug in
the optical bores when a fiber optic cable is not installed, or when
you store the transceiver. When you do remove the plug, keep it for
future use.
 Unnecessary removal and insertion of a transceiver can lead to
premature failure.
 The connector on the fiber topic cable should fit snugly into the port
on the adapter, and the tab should lock the connector into place.
 Do not remove the dust cover from a fiber optic port until you are
ready to connect a fiber optic cable. Dust contamination can
adversely affect the operation of a fiber optic port.
Warning
A transceiver can be damaged by static electricity. Be sure to
observe all standard electrostatic discharge (ESD) precautions,
such as wearing an antistatic wrist strap, to avoid damaging the
device.
Warning
The fiber optic ports contain a Class 1 laser device. When the ports
are disconnected, always cover them with the provided plug.
Exposed ports may cause skin or eye damage.  L4
Note
The cable specifications for the SFP+ transceivers are found in the
installation guides that ship with the devices.
Note
For information about cleaning a fiber optic connector on the
AT-ANC10S adapter, see Appendix B “Cleaning Fiber Optic
Connectors” on page 125.