Installation guide

AT-ANC10S/2 and AT-ANC10S/4 Adapters Installation and User’s Guide
35
Installing a Network Adapter Card
The following installation instructions apply to most systems. For details
about performing the tasks on your particular system, refer to the manuals
that were supplied with your system.
Note
This procedure requires a Phillips-head screw.
Note
The AT-ANC10S/2 and AT-ANC10S/4 adapters require a PCIe x8
PC.
To install the adapter, do the following:
1. Review the “Pre-Installation Checklist” on page 32 and “Reviewing
Safety Precautions” on page 30.
Before installing the adapter, verify that the computer is powered OFF
and that the power cord is unplugged from the power outlet. You
should also be sure to follow all proper electrical grounding
procedures.
Warning
High voltage inside the system presents a safety hazard. Make sure
the power is off before removing the cover.
2. Remove the system cover. Refer to Figure 9 on page 36.