Installation guide

Chapter 1: Introducing the AT-ANC10S/2 and AT-ANC10S/4 Adapters
22
Figure 2. AT-ANC10S/2 Faceplate
The LEDs for the SFP+ slots are described in Table 2.
AT-ANC10S/4
Adapter
The AT-ANC10S/4 adapter, shown in Figure 3 on page 23, has four slots
for SFP+ modules that operate at 10 Gbps in full duplex mode. You cannot
change the speed or duplex mode of the transceiver slots. The maximum
operating distance of an SFP+ slot will vary depending on the SFP+
Table 2. Network Link and Activity LEDs
Port LED LED State Network State
ACT LED Off The slot is empty or the
transceiver in the slot is not
transmitting or receiving
network traffic.
Blinking The transceiver in the slot is
transmitting or receiving
network traffic.
LNK LED Off The slot is empty or the
transceiver has not
established a link to a remote
device.
Steady On The transceiver has
established a link to a remote
device.