Installation guide

AT-ANC10S/2 and AT-ANC10S/4 Adapters Installation and User’s Guide
115
uediag -fump
<ump_image>
Specifies the bin file to update the
UMP firmware.
uediag -help Displays the Broadcom NetXtreme II
User Diagnostics, uediag, command
options.
uediag -I <iteration num> Specifies the number of iterations to
run on the selected tests.
uediag -idmatch Enables matching of VID, DID, SVID,
and SSID from the image file with
device IDs. Used only with -fnvm
<raw_image>.
uediag -log <file> Logs the test results to a specified log
file.
uediag -mba <1/0> Enables/disables Multiple Boot Agent
(MBA) protocol where:
1 = Enable
0 = Disable
uediag -mbap <n> Sets the MBA boot protocol, where:
0 = PXE
1 = RPL
2 = BOOTP
uediag -mbas <n> Sets the MBA/PXE speed, where:
0 = Auto
1 = 10H
2 = 10F
3 = 100H
4 = 100F
6 = 1000F
uediag -mbav <1|0> Enables/disables MBA VLAN, where:
1 = Enable
0 = Disable
uediag -mbavval <n> Sets MBA VLAN (<65536).
uediag -mfw <1/0> Enables/disables management
firmware, where:
1 = Enable
0 = Disable
uediag -t <groups/tests> Disables certain groups or tests.
uediag -T <groups/tests> Enables certain groups or tests.
Table 10. uediag Command Options (Continued)
Command Option Description