Installation guide

Chapter 10: User Diagnostics
114
Performing Diagnostics
At the MS-DOS prompt, type uediag followed by the command options.
The uediag command options are shown in Table 10. For example, to run
all of the diagnostic tests except Group B tests on adapter #1, enter:
C:\>uediag -c 1 -t b
Note
You must include uediag at the beginning of the command string
each time you type a command.
Note
Not all commands are supported on all adapters.
Table 10. uediag Command Options
Command Option Description
uediag Performs all tests on all the ANC10S
networks adapters in your system.
uediag -c <devnum> Specifies the adapter (devnum) to test.
Use all in place of a specific device
number to test all adapters.
uediag -cof Allows tests to continue after detecting
a failure.
uediag -F Forces an upgrade of the image
without checking the version.
uediag -fbc <bc_image> Specifies the bin file to update the
bootcode.
uediag -fipmi
<ipmi_image>
Specifies the bin file to update IPMI
firmware.
uediag -fmba
<mba_image>
Specifies the bin file to update the
MBA.
uediag -fncsi
<ncsi_image>
Specifies the bin file to update the
NCSI firmware.
uediag -fnvm
<raw_image>
Programs the raw image into NVM.