Installation guide

AT-ANC10S/2 and AT-ANC10S/4 Adapters Installation and User’s Guide
105
Note
The path shown in OemPnpDriversPath can be appended with the
path to other applicable drivers.
For an unattended installation, place the driver files for the network
adapter in the $OEM$\$1\Drivers\NIC directory. For Sysprep, the drivers
are located in Drivers\NIC at the root of the system drive. The driver files
are listed below according to the operating system to be installed:
 Windows Server (ia32): bxvbd.inf, bxvbdx.sys, bxvbd.cat,
bxnd.inf, bxnd.cat, bxnd52x.sys, bxndcox.dll, bxdiag.cat,
bxdiag.inf, bxdiagx.sys, wdfcoinstaller01005.dll, and
wUDFUpdate_01005.dll
 Windows Server (x64): bxvbd.inf, bxvbda.sys, bxvbd.cat,
bxnd.inf, bxnd.cat, bxnd52a.sys, bxndcoa.dll, bxdiag.cat,
bxdiag.inf, bxdiaga.sys, wdfcoinstaller01005.dll, and
wUDFUpdate_01005.dll
When applying network properties through an answer file for an ANC10S
network adapter where the PnP iD is the identifier, do the following:
For a BCM57810 Netxtreme II 10GigE - InfId =
"b06bdrv\l2nd&pci_168e14e4"
Currently, the PCI location (PCI bus, device, and function numbers)
method is not supported for a network adapter as an identifier or a network
adapter in the answer file due to a limitation with the Windows operating
system.