User manual

Installation
21
Reconfiguring a Previously Installed Card
If the card is working properly but you wish to reconfigure some
of the I/O parameters, see “Configuring with CardAssistant
Software” on page 14. When you launch CardAssistant, the
configuration window shows the current settings for the card(s)
installed.
If the card is not functioning correctly, the problem may be
caused by a configuration that conflicts with other accessories
installed in the workstation or server. In this case, refer to
“Troubleshooting,” Chapter 8.
Boot ROM Socket
The AT-1700 card is shipped with an unpopulated boot ROM
socket. For a diskless workstation, the card needs a boot ROM to
allow it to load the operating system over the network. If a ROM
is installed, the Boot PROM Enable switch must be set in
CardAssistant’s Configuration menu.
Boot ROMs are application-specific. ATI supplies a range of boot
ROMs for different network environments. Contact your ATI
representative for more information.
613-10434-00.bk Page 21 Monday, March 18, 1996 2:53 PM