User manual

AT-1700
20
Parameters may be combined on the command line.
Here are sample command lines for differing requirements:
setup17 0x300 /I15 /UTP /Bc8000 /T100
setup17 320h /I5 /Bdisable /Fiber
The
/E
parameter is used by itself to prompt CardAssistant to
count the number of AT-1700 cards in the computer rather than
bring up the main menu.
NOTE 1. For the range of values, refer to Table 1 on page 17.
Table 2: Batch Mode Parameter Names
Parameter Function
/I x
x = interrupt level
1
/UTP
selects the UTP (10BASE-T) port
/T x
x = cable impedance for UTP connections
/BNC
selects the BNC port
/FIBER
selects the Fiber Optic port
/AUI
selects the AUI port
/AUTO
configures for automatic port selection
/T100
configures for 100 Ω UTP/STP cable
/T150
configures for 150 Ω STP cable
/Bxxxx
enables the boot PROM at address xxxx
/Bdisable
disables the boot PROM
/E
returns the number of AT-1700s installed
613-10434-00.bk Page 20 Monday, March 18, 1996 2:53 PM