User manual

Installation
15
Launching the CardAssistant program requires that
the card is present. If you have a driver running, you
will not be allowed to open the Diagnostics window
unless you have commented out the driver line in the
batch file (for NetWare) or the
DEVICE=drivername line in config.sys (for an NDIS
driver) and restarted the PC. You may, however,
enter the Configuration window and configure the
adapter card, but the new values do not take effect
until the PC is restarted.
Invoking CardAssistant
1. If you are running CardAssistant from the installation
software diskette, follow steps 2 and 3. If CardAssistant is
installed on your hard disk, skip to step 4.
2. Insert the installation diskette into the appropriate floppy
drive.
3. Type:
floppydrive :setup17
where
floppydrive
is the disk drive containing the
CardAssistant program. Proceed to step 5.
4. CardAssistant is copied onto a hard disk when you install the
driver for the adapter card. Once this is accomplished, you
can type:
path\ setup17
where
path\
is the optional drive and directory.
5. The main menu comes up and you are ready to select one of
the icons.
N
ot
e
613-10434-00.bk Page 15 Monday, March 18, 1996 2:53 PM