User manual

AT-1700

The card works in either a 16-bit ISA slot or an EISA

slot. If you are not using an EISA slot, skip step 3.

3. Run your computer’s EISA configuration utility and make a

note of the I/O resources (I/O Address Range and Interrupt)

available for the adapter card. Follow the EISA utility

instructions, and insert the ATI CardAssistant diskette

when the EISA utility asks for the vendor diskette.

The EISA utility asks which I/O resources to reserve for

the adapter card. You can refer to Table 1 on page 17 and

record the settings you choose. Also note these settings on

the Network Management Summary on the back of your

Quick Reference Guide.

Configuring with CardAssistant Software

Instead of hardware jumpers, the AT-1700 uses software

settings to configure the card. The CardAssistant program’s

interactive mode lets you set these I/O parameters from menus

of choices with your keyboard or mouse. The batch mode allows

you to configure the card on a DOS or OS/2 command line. See

“Running CardAssistant in Batch Mode” on page 19.

613-10434-00.bk Page 14 Monday, March 18, 1996 2:53 PM