System information

Enable
Enables the port.
Disable
Disables the port.
Port Lock
Basic Info
Displays basic information about port lock.
Interfaces Range
Displays information about port lock interfaces range.
MAC Control
MAC Control Sublayer
Displays information about the MAC Control sublayer on a single ethernet-like
interface.
Note - The current firmware version returns a 'noSuchName' value for the Unknown
Opcodes Received and Unknown Opcodes Received (HC) parameters.
MAC Control PAUSE
Displays information about the MAC Control PAUSE function on a single ethernet-
like interface.
Note - Valid MIB Set values for the PAUSE Config parameter are "disabled" and
"enabledXmitAndRcv". Attempting to set this parameter to any other value will
result in the error message: "The error occurred with 'Set' operation. Error: bad
value."
Note - The current firmware version returns a "noSuchName" value for the
Received Frames (HC) and Transmit Frames (HC) parameters.
QoS
Basic Info
Displays basic information about QoS.
Note - Although the current firmware allows the QoS Mode parameter to be set to
'service', the value 'service' is not a valid MIB Set value.
Note - Valid MIB Set values for the Basic Mode parameter are 'vpt', 'dscp' and ‘dscp-
mutation’. However, setting the Basic Mode parameter to ‘dscp-mutation’ will result
in the error message "The error occurred with 'Set' operation. Error: gen Error." In
addition, attempting to set this parameter to ‘none’ or ‘tcp-udp’ will result in the
error message: "The error occurred with 'Set' operation. Error: bad value."
AlliedView™-EMS 3.8 DEVICE MANAGEMENT GUIDE Page 45 of 330