System information

Note - AT-RG600 ADSL: Attempting to configure the parameters under the
Additional Info sub-menu option for LAN 4 will not result in an error but the
new values will not be applied.
Note - AT-RG634A: Valid MIB Set values for the Receive Limit and Transmit
Limit parameters are in the range [0-1000000] inclusive. However, the
current firmware version allows these parameters to be set to more than
the maximum value.
Note - AT-RG656BD : When a LAN or WAN port is configured to auto-
negotiate and is connected to a 100Mbps full or half duplex port on another
device, the current firmware version returns '10000000' for the Speed
parameter under the Standard sub-menu option. As a result, the speed
displayed on the RJ-45 LAN port images is '10' instead of '100'.
Note - AT-RG656BD: The current firmware version returns '???(195)' for the
Port Type parameter of the 100Base-FX WAN port.
Note - AT-RG656BD : By default, the WAN port is enabled. However, once
disabled, it can no longer be enabled until the device is reset to factory
defaults.
Note - AT-RG613xx: Attempting to configure any of the parameters under
the Additional Info sub-menu option while a telnet connection is open will
not result in an error message, but the new values will not be applied.
Voice
Displays information for each voice port.
Note - If the user has no read access to the Admin Info MIB group, the
association of the end-point to the voice port may be incorrect for the
following context menu options:
 Dial Info
 Call Forwarding Info
 CLI Info
 Quality Info
 Statistics
As a result, when a user right clicks on a voice port (e.g. TEL1) and
chooses any of these context menu options, the information that will be
shown may be for TEL 2 instead.
Note - AT-RG634A: The value displayed for the Port parameter is '???(0)'.
Note - AT-RG634A: It may take a while to retrieve information from the
device. As a result, the value 'no such instance' may be displayed by default.
AlliedView™-EMS 3.8 DEVICE MANAGEMENT GUIDE Page 303 of 330