System information

Port Menu
From the Port menu, you can view and edit MIB information about the ethernet and voice
ports.
Utilization
Displays the port's utilization information.
Note - AT-RG613xx: The Utilization field is grayed out if the Port Speed and Mode
parameter is set to auto-negotiate.
Interface Info
Ethernet
Displays ethernet port statistics such as the number of frames received and
transmitted on the port, bytes received and transmitted on the port and port
status.
Note - Valid MIB Set values for the Port Speed and Mode parameter of the
100Base-FX WAN ports should only be '100Mbps full-duplex', '100Mbps half-
duplex', and 'auto sense'. However, the current firmware version allows it to
be set to '10Mbps full-duplex' or '10Mbps half-duplex' as well.
Note - Under the Additional Info sub-menu option, if the Port Speed and
Mode parameter is currently set to '100Mbps full-duplex', it cannot be
changed to '100Mbps half-duplex' directly. You will have to set it to some
other speed and mode first. This is true for all LAN and WAN ports.
Note - The Port Flow Control parameter has a fixed value of 'flow' and
cannot be modified.
Note - Port number assignment displayed in the Additional Info and Standard
Info sub-menu options are inconsistent.
Note - The current firmware version does not return any value for the
Physical Address parameter.
Note - Changing the value of the Port Speed and Mode parameter will result
in the error message: "The error occurred with 'Set' operation. Error: time
out occurred." However, the new value is still set.
Note - It may take a while before the actual values of the Port Description
and Media Type parameters are displayed especially when there is an existing
telnet connection of the device.
Note - The values displayed by Device Manager for the Receive Limit and
Transmit Limit parameters may not be the same as the values displayed by
the CLI.
AlliedView™-EMS 3.8 DEVICE MANAGEMENT GUIDE Page 302 of 330