System information

Note - The Port Mode parameter is not applicable to the AT-CV1KSS line card and should
be ignored. Attempting to configure this parameter may cause the SFP ports to lose
connection.
Note - The Port Duplex Status parameter is not applicable to the AT-CV1KSS line card and
should be ignored.
Note - The SFP port images will always be fiber optic ports even if the actual SFP modules
inserted in the SFP slots have copper ports. This is because the current firmware version
does not allow Device Manager to identify the port type of SFP modules inserted in the SFP
slots.
Note - Configuring the Module Operation Mode parameter may cause the SFP ports to lose
connection.
Note - The current firmware version does not allow Device Manager to detect the presence
or absence of an SFP module in any of the SFP slots. As a result, the SFP slots on the device
image will always show SFP images regardless of whether or not SFP modules are physically
present in the slots.
Note - Valid MIB Set values for the Module Operation Mode parameter are 'link test mode',
'smart missing link mode' and 'missing link'. Attempting to set this to any other value may
result in unpredictable behavior.
AT-CV5000 Modules
AlliedView™-EMS 3.8 DEVICE MANAGEMENT GUIDE Page 259 of 330