System information

Note - To configure the Port Duplex Status parameter of the 100Base-FX port, the Port

Mode parameter must first be set to 'manual'.

Note - The Port Mode parameter value 'auto' is not applicable to the 100Base-FX port.

Note - The Port Speed and Port Duplex Status parameters should not be configured when

the Port Mode parameter is set to 'auto'. This applies to the 10/100Base-TX port.

Note - Setting the Port Mode parameter of the 10/100Base-TX port to 'manual' causes the

Port Duplex Status parameter to be set to 'half-duplex' while setting it to 'auto' causes the

Port Duplex Status parameter to be set to 'full-duplex'.

AT-CV1KSS

LED State Description

LT Green Link Test is enabled

SML Green Smart Missing Link is enabled

ML Green Missing Link is enabled

Note - The current firmware version does not display any value for the Module Revision and

Module Release Cycle parameters.

Note - The Module Serial Number parameter may sometimes display illegal characters at the

end of the legitimate value.

AlliedView™-EMS 3.8 DEVICE MANAGEMENT GUIDE Page 258 of 330