System information

Note - The current firmware version does not allow the correct module number to
be displayed. As a result, the Module Number parameter will display the value
'noSuchName' for all modules.
Remote Port Info
Displays the remote port cofigurable parameters.
Note - Values configured for the following parameters will not be reflected on the
CLI:
• Remote Port State
• Remote Port Duplex Status
• Remote Port Ingress Rate Limit
• Remote Port Egress Rate Limit
OAM Menu
From the OAM Menu, you can view information about OAM capabilities of the the device.
OAM Config
Displays information about the device's administration status, max OAM PDU size
and configuration revision.
Note - The Functions Supported parameter is not supported by the current
firmware version and should be ignored.
OAM Statistics
Displays information about the device's transmitted and received frames, recieved
and transmitted loopback OAMPDU's and recieved and transmitted variable
responses.
OAM Peer Info
Displays information about the device's peer mac address, peer mode and peer
vendor info.
Note - There may be times when Device Manager will not be able to successfully
retrieve OAM peer information. When this happens, all parameters in this table will
display the value "retry over occurred".
Note - The Peer Functions Supported, Peer Multiplexor State and Peer Parser State
parameters are not supported by the current firmware version and should be
ignored.
Loopback
Displays information on how to control loopback state and the status of the
loopback function.
AlliedView™-EMS 3.8 DEVICE MANAGEMENT GUIDE Page 255 of 330