System information

Note - The current firmware version does not allow the Promiscuous Mode and
Port Alias parameters to be configured.
Additional Info
Displays port statistics such as the number of frames received and transmitted on
the port, bytes received and transmitted on the port and port status.
Error Statistics
Displays error statistics.
Detail Info
Displays detailed port information such as duplex mode.
Note - Valid MIB Set values for the Port Flow Control and Port Back Pressure
parameters are 'disable' and 'enable'. Attempting to set these parameters to
'unknown' will cause them to be set to 'enable'.
Note - The Port CoS/QoS Priority and Port STP State parameters are not applicable
to the AT-9400 series and should be ignored.
Spanning Tree Info
Displays the port's spanning tree parameters.
CoS
Displays Class of Service parameters and allows you to configure CoS for a port,
change the default mappings of CoS priorites to egress priority queues and configure
a scheduling method for Class of Service.
Enable
Enables the port.
Disable
Disables the port.
Port Mirroring
Displays Port Mirroring parameters and allows you to create/delete a port mirror.
Note - The current firmware version does not allow the Port Mirroring Status
parameter to be set to 'enabled' if, upon device startup, the Port Mirroring feature is
disabled.
Note - The current firmware version does not allow the Mirroring Source Port
(Ingress) and Mirroring Source Port (Egress) parameters to be set to NULL.
Note - The current firmware version does not allow the Mirroring Destination Port
parameter to be set to 0.
AlliedView™-EMS 3.8 DEVICE MANAGEMENT GUIDE Page 174 of 330