System information

Device Info
Displays general information about the switch.
Note - The current firmware version is unable to return a valid value for the
Hardware Version parameter.
MAC Address Table
Displays a list of static MAC addresses configured on the switch.
Note - The MIB (atiStackSwitch.mib v2.19) supported by the current firmware
version defines the Module ID, Port ID and Port List parameters as "read-write". As
a result, Device Manager displays these parameters as configurable objects.
However, attempting to configure these parameters will show that the firmware
does not accept any value.
Note - The only valid MIB Set value for the Status parameter is 'destroy'. Attempting
to set this parameter to any other value may result in the value being ignored or the
error message: "The error occurred with 'Set' operation. Error: bad value."
Reset
Resets the switch.
Telnet
Starts a Telnet connection to the switch.
WEB Browser
Connects to the switch's HTTP server.
Routing Menu
From the Routing menu, you can view and edit information about the switch's routing
functions.
IP
ARP Table
Displays the ARP cache on the switch.
Address Table
Displays the list of IP interfaces on the switch.
Route Table
Displays the IP routing table on the switch.
IP Statistics
Displays statistics about IP routing, including the number of IP datagrams received.
AlliedView™-EMS 3.8 DEVICE MANAGEMENT GUIDE Page 171 of 330