System information

AlliedView™-EMS 3.8 DEVICE MANAGEMENT GUIDE Page 170 of 330
Device Manager LEDs for AT-9400 Series
LED State Description
RPS Green
Gray
Yellow
An optional redundant power supply is connected to the switch
and is turned on.
There is no redundant power supply connected to the switch.
An optional redundant power supply is connected to the switch
but is turned off.
Note - When connecting to a slave switch, Device Manager does not automatically replace
the master switch image in the main window with the slave switch image. The same is true
when returning to the master switch from the slave switch. To view the updated image,
click on the Refresh option under the Agent menu.
Note - Blocking ports will appear green instead of yellow when the Spanning Tree Status
parameter is set to "enabled" and the Spanning Tree Version parameter is set to "rstp".
Note - AT-9424T/xx: If the Port Speed parameter of the redundant port is operating at
1000Mbps, its equivalent uplink port will also appear active.
Agent Menu
From the Agent menu, you can view and edit the system information for the device, or log
into the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.
Note - Configuring the System Contact, System Name and System Location
parameters may sometimes result in the error message: "The error occurred with
'Set' operation. Error: gen Error." However, the values are still set successfully.
Firmware Info
Displays firmware version.
Network Info
Displays network-related information such as the addresses of the default gateway
and the agents.