System information

Routing Menu
From the Routing menu, you can view and edit information about the router's IP routing
functions.
ARP Table
Displays the mapping of IP addresses to MAC addresses (the ARP cache) on the
router.
Note - The current firmware version does not allow the user to configure the
Physical Address parameter. Attempting to configure this parameter will result in
the error message: "The error occurred with 'Set' operation. Error: gen Error."
Address Table
Displays the list of IP interfaces and their IP addresses on the router.
Route Table
Displays the IP routing table on the router.
Note - The current firmware version does not allow the user to configure the
Destination Port Number parameter. Attempting to configure this parameter will
result in the error messages: "The error occurred with 'Set' operation. Error: gen
Error." or "The error occurred with 'Set' operation. Error: bad value."
Note - The current firmware version does not allow the following parameters to be
configured:
• Destination Metric 1
• Destination Metric 2
• Destination Metric 3
• Destination Metric 4
• Next Hop Address
• Routing Type
• Route Updated Seconds
• Routing Mask
• Destination Metric 5
Attempting to configure these parameters will result in the error message: "The
error occurred with 'Set' operation. Error: gen Error."
IP Statistics
Displays statistics about IP routing, including the number of IP datagrams received.
Note - The current firmware version does not allow the Forwarding Status and the
Default TTL parameters to be configured. Attempting to configure these will result
in the error message: "The error occurred with 'Set' operation. Error: gen Error."
ICMP Statistics
Displays ICMP statistics.
AlliedView™-EMS 3.8 DEVICE MANAGEMENT GUIDE Page 113 of 330