Specifications

Hardware Reference 35
C613-03084-00 REV A
Optional Wall-mount Kit
The wall-mount kit is purchased separately. To order a wall-mount kit, contact
your authorised distributor or reseller for more information, or visit
http:// www.alliedtelesyn.co.nz/support
.
Warning For electrical safety requirements the switch must be mounted with
the front and rear of the switch vertical.
The part number for the wall-mount kit approved for use with the AT-9900
Series switch is:
■ AT-WBRKT-00
How to install a switch using the wall-mount kit
Screw the brackets to the wall with the brackets at the top and the bottom of the
switch.
To install the switch using the wall-mount kit:
1. Ensure that there is sufficient space on the wall for the switch and its
associated cables.
2. Screw the brackets to the sides of the switch using the supplied M4 screws.
The switch is held by wall anchors fixed through the slots in the brackets
(see Figure 1-15 on page 36).
3. Locate where on the wall you want to mount the switch and mark the
position of the slots in the top brackets.
Ensure the positions you have marked on the wall are the correct distance
apart and are horizontal.
4. Fix two wall anchors in the wall, one for each bracket.
5. Hang the switch from these anchors.
Fix additional wall anchors through the bottom brackets, 2 per bracket.
6. Ensure that all wall anchors are tightened sufficiently to secure the switch
firmly against the wall.
7. Check all screws and nuts to ensure they are fully tightened.