Specifications

Hardware Reference 33
C613-03084-00 REV A
An example output is shown below.
Figure 1-14: Output from the show cflash test command, when a test is running
If used when testing is not active, the previous command displays blank
cluster ranges on a CompactFlash card (Figure 1-13 on page 32).
Error messages are displayed when a file write fails. Failure could be due to the
card being removed or an error in the card.
Dual In-line Memory Modules (DIMMs)
Warning Only authorised service personnel should install DIMM.
Unauthorised opening of the switch’s lid may cause danger of injury from
electric shock and may cause damage to the switch.
Synchronous DRAM for AT-9900 Series switches is provided by a single
DIMM.
Approved DIMM for the AT-9924T and AT-9924SP
switches
Warning Only Allied Telesyn supplied DIMMS have been tested and approved
for use with AT-9900 Series switches. If you use DIMM that has not been
approved this may cause unreliable operation and will invalidate the switch’s
warranty.
For AT-9924T or AT-9924SP switches, the following DIMM have been
approved for use:
■ AT-SD128A-00 128MB SDRAM (installed at factory)
■ AT-SD256A-00 256MB SDRAM (upgrade)
■ AT-SD512A-00 512MB SDRAM (upgrade)
Test Progress
Starting cluster = 700
Ending cluster = 1700
Current cluster = 1185
Passed clusters number = 485
Passed sectors number = 1940
Failed clusters number = 0
Failed sectors number = 0
Used Clusters encountered = 0
Duration................ 4417 ms