Specifications

28 AT-9900 Series Switch
C613-03084-00 REV A
The first section of the output shows details of the boards installed in the
switch. There should details of the switch base card, the accelerator card if
installed, and the type of power supply unit or fan only module installed. Both
the part names and the serial numbers of the base card and accelerator card
should be displayed.
If there is no entry for the accelerator card then the switch’s boot process has
not correctly detected the accelerator card’s presence. The most likely cause is
that the accelerator card is not correctly plugged into the slot on the switch’s
base board.
Contact your authorised Allied Telesyn distributor or reseller if an accelerator
card is installed in your switch but the correct details are not displayed in the
output of the show system command.
Record the details of both the base card on the switch and the network
processor accelerator card for later reference. If you have any difficulty with
the network processor accelerator card at any time, contact your authorised
distributor or reseller and quote the serial numbers of both the base card on the
switch and the network processor accelerator card.
How to display information about the accelerator
card
To display information about the accelerator card’s status and memory, use the
command:
show switch accelerator
Figure 1-11: Example output from the show switch accelerator command
Switch Accelerator Configuration
---------------------------------------------------------------------------
Hardware Type .............. AT-ACC01
Mode ....................... IPv6 Acceleration
Status ..................... IPv6 active
Search memory size ......... 128 Mb
Counter memory size ........ 2 Mb
---------------------------------------------------------------------------