Specifications

Hardware Reference 27
C613-03084-00 REV A
To enable Quality of Service (QoS) functionality on the accelerator card use the
hardware filter and the QoS commands. Detailed information about QoS
functionality and hardware filters is in the Quality of Service (QoS) and
Switching chapters of the AT-9900 Series Software Reference.
How to check if an accelerator card is installed
correctly
To confirm that the accelerator card is installed and operating correctly check
that the switch has recognised the card. Turn on the switch and enter the
command:
show system
to display system information. An example output is shown in Figure 1-10 on
page 27.
Figure 1-10: Example output from the show system command
Switch System Status Time 09:35:29 Date 18-Aug-2004.
Board ID Bay Board Name Host Id Rev Serial number
--------------------------------------------------------------------------------
Base 220 9924T/4SP 0 P2-0 61117541
PSU 212 1 AT-PWR01-AC 0 P3-0 58494950
PSU 214 2 AT-FAN01 0 P3-0 6844346
--------------------------------------------------------------------------------
Memory - DRAM :262144 kB FLASH : 16384 kB
--------------------------------------------------------------------------------
SysDescription
CentreCOM 9924T/4SP version 2.7.0-00 13-Jul-2004
SysContact
SysLocation
SysName
SysDistName
SysUpTime
265270 ( 00:44:12 )
Boot Image : at9924bt.fbr size 1005336 10-Jul-2004
Software Version: 2.7.0-00 13-Jul-2004
Release Version : 2.7.0-00 13-Jul-2004
Release built : Aug 15 2004 at 15:32:47
Patch Installed : NONE
Territory : japan
Help File : help.hlp
PSU1: (AC) Fan: Normal Temp: Normal Power: Normal
PSU2: (FAN) Fan: Normal
Current temperature : Normal
-----------------
Configuration
Boot configuration file: flash:swload.cfg (exists)
Current configuration: flash:swload.cfg
Security Mode : Disabled
Warning (2048284): No patches found.