Specifications

Hardware Reference 17
C613-03084-00 REV A
Further configuration is necessary if you wish to access the switch’s full
switching capabilities. How to configure the switch is described in detail in the
AT-9900 Series Software Reference.
FAIL: BBR test. Error address =
12345678
The BBR size/location test failed at the given location. The
test at this location failed, indicating the end of memory,
but a valid location was discovered in the 255 long words
following this location. The BBR system will need to be
replaced. Contact your Authorised Allied Telesyn distributor
or reseller.
FAIL: BBR test, only 16k bytes
found
The BBR size/location test completed, but only the displayed
amount of memory was found. This amount is less than the
minimum required to run the switch software.
INFO: Self tests complete The start-up tests have finished.
INFO: Downloading switch
software
The process of downloading the switch software and vector
table from ROM is about to begin.
ERROR: Code load retried
FAIL: Code load failed
The load of the code from ROM to RAM failed. The load is
retried a number of times. Each time a failure occurs, the
ERROR message is displayed. If the maximum number of
attempts is reached, the FAIL message is displayed.
INFO: Initial download
succeeded
The start-up tests and download are complete, and the
switch software is about to be started. If the default install
is a compressed release, the release will now be
decompressed. This may take a few seconds.
INFO: Downloading
compressed release. This may
take up to 1 minute...
INFO: Loading software into
memory. This may take up to 1
minute...
The main switch software is about to be loaded into RAM.
If the release is a compressed release, the release will be
decompressed.
INFO: Executing configuration
script <script-name>
The configuration commands stored in <script-name> are
being executed. If an error is found in the script, one or
more ERROR messages will be displayed.
INFO: Switch startup complete The start-up process is complete and the switch will now
perform basic switching operations.
Table 1-3: Switch start-up messages and their meanings (Continued)
Message Description