Specifications

Hardware Reference 15
C613-03084-00 REV A
To change the account password, use the command:
set password
How to configure the switch is described in detail in the AT-9900 Series Software
Reference.
How to access help
Before help is used for the first time, you must define the help files. To define
the files, enter:
set help=help-filename
where help-filename is the name of a help file stored in flash.
To see a list of files stored in flash, enter:
show file
Help files have an .hlp extension.
To display a list of help topics, enter:
help
To display help on a specific topic, enter:
help topic
Alternatively, type a question mark (?) at the end of a partially completed
command to see a list of valid options.
Start-up procedures
When the switch starts up following either a power cycle or an
operator-initiated reboot (using the Reset button or restart command), a series
of start-up messages is sent to the terminal or PC connected to ASYN0
(Figure 1-4 on page 15).
Figure 1-4: Switch start-up messages
After the self tests are complete, the manager is given the option of forcing a
mandatory boot from the EPROM (flash) release. The message:
Force EPROM download (Y)?
INFO: Self tests beginning.
INFO: RAM test beginning.
PASS: RAM test, 131072k bytes found.
INFO: BBR tests beginning.
PASS: BBR test, 512k bytes found.
INFO: Self tests complete
INFO: Downloading switch software.
Force EPROM download (Y) ?
INFO: Initial download succeeded
INFO: Executing configuration script <boot.cfg>
INFO: Switch startup complete
Manager >