Install guide

Quick Install Guide 9
Follow these steps to install the switch using the 19-inch
rack-mount kit
1. Ensure the rack has sufficient space for the switch and its associated
cables.
2. If necessary, install cage nuts at the front and the rear of the rack.
3. Remove the rubber feet from the switch.
4. Screw the front brackets to the sides of the switch using the supplied
M4 screws (see Figure 1-1 on page 9).
Figure 1-1: Fitting front rack-mount brackets on the switch
5. Measure the depth of the rack to determine the correct position to
attach the rear brackets to the switch.
6. Screw the rear brackets to the sides of the switch using the supplied
M4 screws (see Figure 1-2 on page 10 and Figure 1-3 on page 11).
Front Bracket
Bracket
Rear bracket
A
A
A
Key:
A
screw
Switch
RMOUNT3
A
9900qig.fm Page 9 Thursday, September 2, 2004 9:41 AM