Install guide

Quick Install Guide 11
Figure 1-3: Fitting rear rack-mount brackets on the switch
7. Mount the switch into the rack from the front and attach to the rack
using rack mounting screws. Two people may be required to safely
support the switch until the brackets are screwed to the rack.
8. Fit the adjustable bracket extensions onto the rear brackets but do not
tighten the nuts (see Figure 1-2 on page 10 and Figure 1-3 on page 11).
The adjustable bracket extensions are rotationally symmetrical when
attached to the rear brackets. When viewed from the rear of the
switch, the flanges on the bracket extensions are at bottom on the right
and at the top on the left. This is to allow adequate clearance when a
power supply unit or fan only module is removed from the switch.
9. Attach the adjustable bracket extensions to the rack using appropriate
rack mounting screws.
10. Tighten the nuts securing the adjustable bracket extensions to the rear
brackets.
11. Check all screws and nuts to ensure they are fully tightened.
RMOUNT5
Key:
A
B
screw
nut
Adjustable bracket
extension
B
Switch
A
A
B
Left Rear Bracket
9900qig.fm Page 11 Thursday, September 2, 2004 9:41 AM