Specifications

Hardware Reference 35
C613-03043-00 REV B
Do not attempt to install DIMM without observing correct antistatic
procedures. Failure to do so may damage the DIMM and switch. If you are
unsure what the correct procedures are, contact your authorised Allied Telesyn
distributor or reseller.
8. To remove an existing DIMM.
Before removing the switch’s lid, the power cord and, if connected, RPS power
cord should be disconnected to reduce risk of electrical shock.
The DIMM is held in place by two retaining latches, one latch at each end
of the DIMM slot. Release these latches and carefully pull the DIMM from
the DIMM slot.
The DIMM slot’s location is shown in Figure 17 on page 35.
Figure 17: AT-9800 Series DIMM slot.
9. Align and insert the first DIMM.
Holding a DIMM at an angle of about 30 degrees from horizontal, align the
notches on its connector strips with the notches on an empty DIMM slot
(see Figure 18 on page 36).
Insert the DIMM into the DIMM slot, sliding it along the two DIMM
guides until the retaining latches automatically click into place. The latches
should hold the DIMM firmly in place.
CAM mounts
Switch chip
CAM slot
BatteryCompact Flash
DIMM slot
CPU
PAC slots
clayPCB
Ports
Correct CAM
orientation
Chamfers
PAC pillars