Specifications

Hardware Reference 11
C613-03043-00 REV B
6. Click “ASCII Setup” to display the ASCII Setup dialog box. Uncheck:
• “Echo typed characters locally”.
• “Append line feeds to incoming line ends”.
Set other parameters as required.
• Click “OK” twice to close all dialog boxes.
7. Save the current session. From the File menu, select:
•“Save”.
This creates a connection icon with the name you assigned in the
HyperTerminal group. To use the configuration:
• Double-click the connection icon in the HyperTerminal group.
When the HyperTerminal window appears, press:
• [Enter] a couple of times.
The switch’s log in prompt will appear.
Switch Start-up
This section outlines the log in and start-up procedures for your switch.
Although the switch will perform basic switching operations without being
configured, you will need to go through these log in and start-up procedures if
you wish to configure the switch and access its full layer 3 switching
capabilities.
To log In
To log in you must first connect the switch to a terminal or PC. This can be
done using the RS-232 Terminal Port (ASYN0). A terminal cable suitable for
use with ASYN0 is supplied with each switch.
Using the supplied terminal cable, or a cable you have made by following the
instructions in “Useful Cables” on page 16, connect your terminal or PC to
ASYN0.