Specifications

32 AT-9800 Series Switch
C613-03059-00 REV F
7. Align the CAM.
Position the CAM over the CAM slot on the switch base board, as shown in
the following figure. The three support pillars located on the board should
be aligned with the holes on the CAM, and the CAM’s chamfers should be
pointing to the switch’s PSU.
8. Insert the CAM.
Warning Forcing a misaligned CAM will damage the CAM’s connector and
CAM slot.
Press the CAM firmly into place. Secure the CAM to the support pillars
using the supplied screws.
The CAM is now ready to test.
CAM mounts
Switch chip
CAM slot
BatteryCompact Flash
DIMM slot
CPU
Ports
Correct CAM
orientation
Chamfers