Specifications

Hardware Reference 37
C613-03059-00 REV E
Figure 16: Example output from the SHOW SWITCH command for a 9800 Series
switch with upgraded CAM.
If any CAM test fails, check that the CAM is correctly installed in its slot and repeat the
tests. Contact your authorised Allied Telesyn distributor or reseller if the CAM does not
operate correctly.
Installing DIMM
AT9800 Series switches have one DIMM slot. The slot can be populated with
either a 128 MByte DIMM or a 256 MByte DIMM.
Only Allied Telesyn supplied DIMMS have been tested and approved for use
with AT-9800 Series switches. Using DIMM that has not been approved may
cause unreliable operation and will invalidate the switch’s warranty.
For AT-9800 Series switches, DIMM should only be installed by authorised
service personnel. Unauthorised opening of the switch’s lid may cause danger
of injury from electric shock, damage to the switch, and invalidation of the
product warranty.
To install DIMM in an AT-9800 series switch:
1. Avoid injury by working in a safe environment.
The workspace should be free of hazards, and there should be sufficient
room to lay out the switch, DIMM, and tools.
2. If fitted, disconnect the switch’s redundant power supply.
3. Disconnect the mains power cord.
Switch Configuration
------------------------------------------------------------
CAM size ( entries ) ....... 204800
Switch Address ............. 00-00-cd-05-01-0f
Learning ................... ON
Ageing Timer ............... ON
Number of Fixed Ports ...... 16
Number of Uplink Ports ..... 0
Mirroring .................. DISABLED
Mirror port ................ None
Ports mirroring on Rx ...... None
Ports mirroring on Tx ...... None
Ports mirroring on Both .... None
Number of WAN Interfaces ... 0
Name of Interface(s) ....... -
Ageingtime ................. 300
VLAN classification ........ To be defined
UpTime ..................... 00:01:21
Hashingfiled ............... L2 L3 L4
-----------------------------------------------------------